Chapter 2
Switch Installation
StackPower Partitioning Examples
Figure 2-9
In
Figure
Figure 2-9
In
Figure
stacks. The top two switches share power, and the bottom switch is now a separate stack.
Figure 2-10
Installing the Switch
•
•
•
The illustrations shown in this section show the Catalyst 3850-48 PoE+ switch as an example. You can
install other Catalyst 3850 switches following the same procedures.
OL-26779-02
and
Figure 2-10
show StackPower stacks of Catalyst 3850 switches with failover conditions.
2-9, the StackPower cable 2 is faulty. Therefore, this stack does not provide redundancy.
Example of a StackPower Stack with a Failover Condition
2-10, StackPower port B on the center switch has failed and this stack partitions into two
Example of a Partitioned StackPower Stack with a Failover Condition
Rack-Mounting, page 2-12
Table- or Shelf-Mounting, page 2-16
After Installing the Switch, page 2-16
1
2
3
1
2
Catalyst 3850 Switch Hardware Installation Guide
Installing the Switch
2-11