Entering The Initial Configuration Information; Ip Settings; Configuring The Setup Program - Cisco Catalyst 3850 Hardware Installation Manual

Appendix C Configuring the Switch with the CLI-Based Setup Program
When the Remove the Program window appears, click Remove.
Step 4
When the InstallShield Wizard Completed window appears, click Finish.
Step 5
Uninstalling the Cisco Microsoft Windows Vista and Windows 7 USB Driver
Disconnect the switch console terminal before uninstalling the driver.
Note
Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 1
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 2
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 3
When the Remove the Program window appears, click Remove.
Step 4
Note If a User Account Control warning appears, click Allow - I trust this program to proceed.
When the InstallShield Wizard Completed window appears, click Finish.
Step 5

Entering the Initial Configuration Information

To set up the switch, you need to complete the setup program, which runs automatically after the switch
is powered on. You must assign an IP address and other configuration information necessary for the
switch to communicate with the local routers and the Internet. This information is also needed to use
Cisco Network Assistant to configure and manage the switch.

IP Settings

You need this information from your network administrator:
•
•
•
•
•
•

Configuring the Setup Program

If your switches are stacked and there are multiple console connections to individual switches in the
stack, the initial setup dialog appears at the console where you first press Enter.
OL-26779-02
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password
Enable password
Telnet password
Entering the Initial Configuration Information
Catalyst 3850 Switch Hardware Installation Guide
C-5