Charging Procedure; Maintenance; X5 Battery Pack Storage - Honeywell MicroDock II Operating Manual

Charging Procedure

To charge a detector in a charging docking module, complete the following:
1. Connect the AC adapter of the charger to the CHARGE port on the station
and then plug the cord into the AC outlet. The charging LED briefly lights
red then green during the self-test. The light then powers off.
2. Deactivate the detector and insert into the charging cradle (bottom first).
The charging LED then lights red.
Ensure the detector is inserted correctly onto the contact pins.
3. Allow the battery to obtain a full charge. A full charge requires 2-4 hours,
depending upon how many docking modules are connected to the
station.
The charging LED turns green when charging is complete.
The charging LED powers off when the detector is removed from the
charger.

Maintenance

WArNINg
No user-serviceable parts inside.
To maintain the station in good operating condition, perform the following basic
maintenance as required.
•
To ensure quality product operation, maintain a log of all maintenance that
is performed.
•
Clean the exterior with a soft, damp cloth. Do not use solvents, soaps, or
polishes.
•
Confirm that the inlet filter is free of dirt and replace it if required. To order
replacement parts, refer to
•
Do not immerse the station in liquids.

X5 Battery Pack Storage

When storing for extended periods of time, ensure that the detector is fully charged
and recharged every 30 days.
58
Charger Status Description
Red
Green
Off
Table 19. Charger Status LED
Charging normally
Charge complete
Charge or temperature fault
Replacement Parts and
MicroDock II Automatic Test and Calibration Station
Accessories.