Honeywell MicroDock II Operating Manual page 10

Battery Chargers
»
If the charger is damaged or parts are missing, contact your local Distributor
or Honeywell Analytics immediately.
»
Do not change or charge the batteries in a hazardous location. Do not use
the charger in a hazardous location. Failure to adhere to these precautions
can lead to fire and/or explosion.
»
Read and adhere to all instructions and precautions that are provided
with the charger. Failure to do so can result in fire, electric shock, or other
personal injury and/or property damage.
»
Use only Honeywell Analytics approved batteries; do not use alkaline or
other rechargeable batteries with this charger.
»
For indoor use only.
»
Do not immerse the charger in liquids.
»
Do not expose the charger to electrical shock or severe continuous
mechanical shock.
»
Ensure the detector battery pack is locked in place before operating the
detector.
»
To eliminate the risk of electrical shock, disconnect and deactivate the
charger when cleaning or performing maintenance.
»
Avoid touching the charger and detector contact pins.
»
Substitution of components may impair Intrinsic Safety of the detector
under charge.
»
Do not charge the battery pack with any other charger.
»
Do not attempt to disassemble, adjust, or service the charger unless
instructions are provided to perform a procedure, or a part is listed as
a replacement part in the user manual . Use only Honeywell Analytics
replacement parts.
»
The charger warranty will be void if a customer, personnel, or third parties
damage the charger during repair attempts. Any non-Honeywell Analytics
service/repair attempts will void this warranty.
Symbol Description
Approved to both U.S. and Canadian Standards by the Canadian
Standards Association
Conforms to European Union Directives
10
Table 1. International Symbols
MicroDock II Automatic Test and Calibration Station