Table of Contents
Advertisement
\Vn
Extended Connect Message
The "\Vn" command controls the presentation of the connect message after the "CONNECT" result
valid range of n is 0 to 1. The default setting is 1. This parameter does not apply when the "Result Code
Format" (Vn) command is "Numeric" (V0).
"\V0" causes the "CONNECT" result code to consist only of the text "CONNECT".
"\V1" causes the "CONNECT" (e.g., CONNECT 33600 /LAPM /V.42bis) result code to contain additional text
specifying the bit rate, error-control protocol and compression protocol.
Z
Reset to default Configuration
The "Z" command causes all configuration variables to be reset to the internal defaults, therefore this command
has the same effect as "&F". In addition, if the modem is in the Command Escape mode, the link is terminated.
&F
Set to Default Configuration
The "&F" command causes all configuration variables for the modem to be immediately reset to the internal
factory defaults.
After every call attempt, the MultiAccess modem automatically returns to factory settings. After each call
Note:
attempt, the user specific data application must re-initialize the modem to the desired parameters if the factory
defaults are not sufficient for your application.
MultiAccess Communications Server MA30120 User Guide
Appendix B – Modem Commands
code.
The
146
Advertisement
Table of Contents
