Table of Contents
Advertisement
Chapter 2 – Installation
User Authentication
User authentication is established using Radius Client and Radius Server screens. The Radius Client informs
the MultiAccess of where the Radius Server is located. If your network already has a Radius Server, you do not
have to enter the Radius Server screens. The Radius Server screens are only used when the Radius Server in
the MultiAccess is going to be used. Initially the Radius Server > Default User Setup screen displays the default
settings that are used for dial in network access. Initially these default settings are all that you should need to
authenticate a remote user.
When using the internal Radius Server, you must use the IP address of network card 1 (eth0).
Note:
Radius Client
1. Choose User Authentication >Radius Client.
2. Click on Line Interface and select the Line number you selected in the Line Interface screen.
MultiAccess Communications Server MA30120 User Guide
28
Advertisement
Table of Contents
