Table of Contents
Advertisement
A R M I N G AN D L E AV I N G W I T H O T H E R S S T A Y I N G
If you are arming and leaving with other family members remaining home:
1
Check the Touchpad indicators. The green
dow will read "SYSTEM READY", indicating that the system is ready to arm.
SYSTEM READY
• If the green STATUS light is off and zones are scrolling in the display, a perimeter zone is faulted or a moni-
2
Press the STAY button.
The Touchpad will voice prompt the correct action.
STAY
•
The LCD window will read "ARMING STAY MODE" during the exit delay time period.
3
Open the door, exit and close the door
home. The LCD window will read "EXIT AND LOCK DOOR TO
ARM-STAY".
4
Lock the deadbolt to arm the system.
•
•
Note: If you lose your deadbolt key, see page 24 for activating a special "Lost Key Mode".
tored deadbolt (other than your exit door) is unlocked (if the primary exit door is unlocked, the LCD window
will read "DOOR UNLOCKED"). Check the open zones listed and close the door, window, or lock the dead-
bolts as needed. If you cannot immediately secure the zones or lock the deadbolts, they may be bypassed
(see page 12).
If you change your mind after pressing STAY, press RESET to clear arming.
If the deadbolt has not been locked within the exit delay
time (usually 60 seconds of pressing STAY), the system
will revert back to a disarmed state.
The deadbolt can be locked from the inside by those
remaining home.
light must be ON-STEADY, and the LCD win-
STATUS
, with others remaining
"System is arming
in Stay mode"
"Please lock door to
arm in Stay mode"
"System armed
Stay"
9
Advertisement
Table of Contents
