NAPCO FREEDOM F-64TP Operating Manual page 26

ENROLL MASTER I-FOB
ENROLL USER I-FOB
26
U S E R P R O G R A M M O D E
2. Repeat this process to increment (or decrement) the minute as needed. Press ENTER
move the cursor to the right and press the YES or NO buttons to toggle between "A" and
"P" (for AM and PM). When finished, press MENU to save and proceed to the next op-
tion, "ENROLL MASTER I-FOB Y/N".
Create Master I-FOB
Y/N
The I-FOB is a uniquely coded digital key that performs the following functions when in-
serted into the Touchpad I-FOB slot:
• Disarm an armed system
• Silence an active alarm
• Reset a fire alarm
The Master I-FOB supplied with your system also allows access to additional features within
the Touchpad Menu Mode (see page 21), including access to this User Program Mode.
Note: Only one Master I-FOB can exist within the system. Because the Master I-FOB must
be used to enter this User Program Mode menu, this option "Create Master I-FOB" is in-
cluded in case your existing Master I-FOB--although still working--is perhaps physically dam-
aged in some way and you wish to physically replace it with a new I-FOB (contact your secu-
rity professional and order part F-IFOB). If you press YES to this selection, the Touchpad will
prompt you to insert a new I-FOB, thus replacing the existing Master I-FOB. (In theory, you
can insert the existing Master I-FOB, but this redundant operation will only overwrite the exist-
ing valid Master I-FOB code, thus "re-creating" a Master I-FOB). Note: The Master I-FOB
allows access to all system security features and thus should be kept in a secure location.
Create User I-FOB
Y/N
In addition to allowing the disarming of the system and silencing the siren, User I-FOB's al-
low limited access to system features. You can add up to 5 additional "User" I-FOB's to the
system. Create a User I-FOB as follows:
1. Obtain a new I-FOB from your security professional (order part F-IFOB).