DigiDesign C 24 Manual page 118

Internal
The Internal test verifies the first stage of Ether-
net communication by sending data packets
through the unit's Ethernet link chip.
To perform the Internal Ethernet test:
From the Ethernet Test page, press the en-
coder switch that corresponds to "Internal."
To restart the "Sent" and "Received" packet
counts:
Press the encoder switch that corresponds to
"Restart Counts."
To exit the Internal Ethernet test:
Press the encoder switch that corresponds to
"Exit."
External
The External test verifies the second stage of
Ethernet communication by sending data pack-
ets out of the C|24 Ethernet port and back into
the unit using an Ethernet loopback connector
(included with C|24).
To perform the External Ethernet test:
If Pro Tools is running, quit Pro Tools.
1
Disconnect C|24 from the Ethernet network.
2
Plug the Ethernet Loopback connector into
3
the C|24 Ethernet port.
From the Ethernet Test page, press the en-
4
coder switch that corresponds to "External.
To restart the "Sent" and "Received" packet
counts:
Press the encoder switch that corresponds to
"Restart Counts."
110 C|24 Guide
To exit the External Ethernet test:
Press the encoder switch that corresponds to
"Exit."
LED Test Page
The LED tests let you test all red, yellow, or
green LEDs on C|24 individually.
To test the LEDs:
From the LED Test page, press the encoder
switch that corresponds to any of the following
to test all LEDs of the specified color:
• Red LEDs
• Yellow LEDs
• Green LEDs
To exit an LED test:
Press the encoder switch that corresponds to
"Exit."
Vegas Mode
Vegas mode randomly lights every switch,
meter, and display on the unit, and runs the fad-
ers in a sine wave pattern.
To enter Vegas mode:
Press the encoder switch that corresponds to
"Vegas Mode."
To vary the rate of LED blinking and fader motion:
Turn the Scrub/Shuttle wheel or any rotary
encoder.
To exit Vegas mode:
Press any switch on the unit.