DigiDesign C 24 Manual page 108

Punching Out of Plug-in Automation
During an Automation Pass
To punch out of writing automation for a plug-in
parameter during an automation pass:
Press the Insert switch in the track's channel
1
strip.
For the plug-in you want to display, press the
2
encoder switch that corresponds to "more."
Press the Select/Auto switch in the Switch
3
Functions section so that it is lit.
Press Play to begin the automation pass.
4
During the automation pass, press a flashing
5
encoder switch to punch the corresponding pa-
rameter out of automation write mode.
When you are finished, press the Select/Auto
6
switch in the Switch Functions section so that it
is unlit.
Previewing Automation
(Pro Tools HD Only)
To preview a new automation value for a control:
Enable the track for automation by cycling its
1
Automation Mode switch to enable Touch,
Latch, or Touch/Latch mode.
Enable the automation type by pressing its
2
switch in the Automation Enable section.
Hold the Command/Ctrl Modifier switch and
3
press the Off switch in the Global Automation
Modes section. The Off switch flashes to indi-
cate Preview mode.
Isolate a control by moving it.
4
Start playback and adjust the isolated control
5
to audition the new automation value.
100 C|24 Guide
To suspend Preview mode;
Hold the Command/Ctrl Modifier switch and
press the Read switch in the Global Automation
Modes section.
To punch a preview value to the automation
playlist:
Hold the Command/Ctrl Modifier switch and
press the flashing Off switch n the Global Auto-
mation Modes section.
Capturing Automation
(Pro Tools HD Only)
To capture automation values:
Enable the tracks whose automation values
1
you want to capture by cycling their Automa-
tion Mode switches to a write-enabled state
(Write, Touch, Touch/Latch, or Latch).
Enable all of the automation types you want
2
to capture by pressing their switches in the Au-
tomation Enable section.
Start playback.
3
When you reach a location where you want to
4
capture the current automation states, hold the
Command/Ctrl Modifier switch and press the
Touch switch in the Global Automation Modes
section.
To punch captured automation values:
Move to a location where you want to apply
1
the captured automation states.
Hold the Command/Ctrl+Ctrl/Win Modifier
2
switches and press the Touch switch in the Glo-
bal Automation Modes section.