Floppy Disk Drive Connector - DFI G7L332-L User Manual

2
Hardware Installation

Floppy Disk Drive Connector

3 3
3 4
2 1
The floppy disk drive connector supports standard floppy disk
drives. The 34-pin connector on the floppy cable can be placed into
the header only if pin 1 of the connector is aligned with pin 1 of the
header.
Connecting the Floppy Disk Drive Cable
Install one end of the floppy disk drive cable into the shrouded
floppy disk header on the system board and the other end-most
connector to the drive you want to designate as Drive A. If you are
connecting another drive (Drive B), install the middle connector of
the cable to the drive. The colored edge of the daisy chained ribbon
cable should be aligned with pin 1 of the header.
BIOS Setting
Enable or disable this function in the Integrated Peripherals submenu
("Super I/O Device" field) of the BIOS. Refer to chapter 3 for more
information.
43