Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Da-Lite Manuals
  4. Projection Screen
  5. Large advantage electrol
  6. Instruction book

Da-Lite Large advantage electrol Instruction Book

Hide thumbs Also See for Large advantage electrol:

Advertisement

Quick Links

Download this manual
Instruction Book for
Large advantage
eLectroL
®
®

Advertisement

loading
Need help?

Need help?

Do you have a question about the Large advantage electrol and is the answer not in the manual?

Questions and answers

Related Manuals for Da-Lite Large advantage electrol

Summary of Contents for Da-Lite Large advantage electrol

  • Page 1 Instruction Book for Large advantage eLectroL ® ®...

  • Page 2: Important Safety Instructions

    One mounting bracket is required for assembly, your installation is now complete. Continue to every 4' of case length. step 4 if your Large Advantage Electrol was ordered as a 2. Tighten bolts until trim flange is flush with ceiling. complete unit.
  • Page 3 sCreeN ANd roller AsseMBlY iNsTAllATioN Tools required for screen and roller assembly: 9/16“ Open Wrench 1/2“ Open Wrench 5/32“ Hex Key or Socket Driver or Socket Driver If your screen was shipped with the motor and roller already installed proceed to step 7. 1.
  • Page 4 lArge AdVANTAge eleCTrol iNsTAllATioN ® ® (Suggested) 1/2" Threaded Rod (Not Included) Attached to 9-1/8" Mounting Bracket Electrical Junction Box Screen Roller 12-3/16" 11" Audience Side 11-7/16" Self-Trimming Flange Self-Trimming Access Door Flange Finished 13-1/8" 2-3/16" 10-15/16" Ceiling Variable Position Mounting Brackets Electrical Junction Box...
  • Page 5 AdJusTMeNT Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use a screw driver or 5/32"...
  • Page 6 120V WiriNg diAgrAM WiTH oPTioNAl BuilT-iN loW VolTAge CoNTrol NOTE: 20-24 AWG wire recommended for connecting wall switch to low voltage controller. Caution: Do not use 3-position high Voltage roCker switCh with this unit! this will Damage the low Voltage Control boarD. Front of Back of Wall Wall Switch...
  • Page 7 240V WiriNg diAgrAM WiTH oPTioNAl BuilT-iN loW VolTAge CoNTrol NOTE: 20-24 AWG wire recommended for connecting wall switch to low voltage controller. Caution: Do not use 3-position high Voltage roCker switCh with this unit! this will Damage the low Voltage Control boarD. Front of Back of Wall Wall Switch...

  • Page 8: Troubleshooting

    TrouBlesHooTiNg Visit www.da -lite.com/products/tutorials.php to find installation You can contact us by email at info@da-lite.com or by phone at and troubleshooting tutorials. You will also find a link to Live 800.622.3737 or 574.267.8101 with any additional Chat for interactive support.
  • Page 12 For IncIdentaL, dIrect, or conSeQUentIaL daMageS oF anY natUre. In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137, Warsaw, IN 46581-0137, 574.267.8101, 800.622.3737.