Download Print this page

Da-Lite Large Dual Masking Electrol Instruction Book

Advertisement

Quick Links

INSTRUCTION BOOK FOR
Large Dual Masking Electrol

Advertisement

loading

Summary of Contents for Da-Lite Large Dual Masking Electrol

  • Page 1 INSTRUCTION BOOK FOR Large Dual Masking Electrol...
  • Page 2: Important Safety Instructions

    Important Safety Instructions When using your video equipment, basic safety precautions should always be followed, including the following: Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3.
  • Page 3: Pre-Installation

    Pre-Installation Carefully unpack screen. 3. Do not remove the wrapping paper or pull the orange string until the screen is installed. 2. Make sure to recheck measurements of screen location before installation. Screens 14' wide and over use an ironing board to flatten the fabric.
  • Page 4: Important Note

    ATTENTION! Le masque ne doit pas être ajusté sur place pour régler la chute. Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use a screw driver or allen wrench to make adjustments.
  • Page 5 ATTENTION! Le masque ne doit pas être ajusté sur place pour régler la chute. Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use a screw driver or allen wrench to make adjustments.
  • Page 6 Large Dual Masking Electrol Instructions ® ⁄ " ⁄ " Length = Fabric Width + 19", All Sizes Mounting Bracket ⁄ " (3 Provided) Electrical Outlets Motor End ⁄ " Suggested Methods Of Installation NOTE: Unit is not to be installed in air handling space.
  • Page 7: Troubleshooting

    Troubleshooting Symptom Cause Solution Verify 115-125V (or 220-240V). If insufficient voltage, rewire Incorrect line voltage. incoming electric line.. Branch circuit fuse blown. Replace fuse. Tripped branch circuit breaker. Reset circuit breaker. Check above. Tighten all loose wire connections. Correct any improper connections. “Down”...
  • Page 8 OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE. In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137, Warsaw, IN 46581-0137, (574) 267-8101, (800) 622-3737.