imagistics DL200 Operating Manual page 213

6-44
10. When This Type of Copy is Produced
Symptom
The copy has lines.
1139O1670A
The copy has dark specks or
spots.
1074O111
The edge of the copy is
dirty.
1074O112
The image on the copy is not
aligned properly.
1074O113
* Call your Technical Representative if these procedures do not correct the problem.
Possible Cause
The Original Glass surface is dirty. Wipe the Original Glass clean with
The Original Pad or Document
Transport Belt is dirty.
The original is very thin or highly
transparent.
The original is 2-sided.
The Original Pad is dirty.
You have selected a paper size
larger than the original.
(When the zoom ratio is set at full
size ×1.000)
The original is not placed in the
correct position.
(When the zoom ratio is set at full
size100%)
The reduction ratio selected is not in
accord with the paper size. (When
doing manual reduction copying.)
The original is not placed in the
correct position.
The originals may not be suitable
for use in the document feeder.
Something is sticking to the
Original Glass.
The document guides are not
positioned along the edges of the
paper.
Curled paper was loaded into the
paper drawer.
Action
a soft dry cloth. p.7-10
Wipe the Original Pad clean with a
soft cloth dampened with alcohol.
p.7-11
Place a blank sheet of paper over the
original. p.2-27
The information on the back side of
a 2-sided, thin original may be
slightly reproduced on the copy. Set
the machine into the Manual
Exposure mode and, using
[Lighter], make the exposure level
lighter. p.3-42
Wipe the Original Pad clean with a
soft cloth dampened with alcohol.
p.7-11
Select the same paper size as the
original. p.3-5
Or, use Auto Size to enlarge the
copy to the appropriate size.
p.3-12
Select the same paper size as the
original. Or, reload the paper in the
same direction as the original.
p.3-5
Select the zoom ratio according to
the paper size. p.3-12
Or, use Auto Size to reduce the copy
to the appropriate size. p.3-12
Place the original correctly on the
Original Glass against the Original
Width Scale. p.2-26
Or, load it in the document feeder
correctly along the Document
Guide Plates. p.2-23
Raise the document feeder and
place the originals on the Original
Glass one at a time, instead of using
the document feeder. p.2-26
Wipe the Original Glass clean with
a soft dry cloth. p.7-10
Slide the document guides against
the edges of the paper.
Flatten the paper before loading it.