Replacing The Card Reader - Lenovo ThinkStation E32 User Manual

8. Install the screw to secure the card reader bracket to the chassis.
Figure 21. Installing the screw that secures the card reader
9. Connect the card reader cable to Front USB connectors on the system board. See "Locating parts on
the system board" on page 12.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 93.

Replacing the card reader

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
To replace the card reader, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 32.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 32.
4. Locate the card reader drive bay. See "Locating internal drives" on page 13.
40
ThinkStation E32 User Guide