Replacing the hard disk drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the hard disk drive.
Note: This section also applies to computer models with a 2.5-inch solid-state drive.
To replace the hard disk drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 32.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 32.
4. Press the release tab
Figure 41. Pivoting the drive bay assembly upward
5. Disconnect the signal cable and the power cable from the hard disk drive.
1
as shown and pivot the drive bay assembly upward.
.
Chapter 5
Installing or replacing hardware
51