3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 32.
4. Locate the power switch. See "Locating components" on page 11.
5. Press the release tab
Figure 86. Pivoting the drive bay assembly upward
6. Disconnect the power switch cable from the power switch connector on the system board. See
"Locating parts on the system board" on page 12.
7. Push the power switch inward through the hole to disengage it from the chassis.
Figure 87. Removing the power switch
1
as shown and pivot the drive bay assembly upward.
.
Chapter 5
Installing or replacing hardware
81