Lenovo ThinkStation E32 User Manual page 59

8. Insert the mSATA solid-state drive storage converter to the chassis and push the converter to the left to
align the screw hole in the converter with the corresponding hole in the chassis. Then install the screw
to secure the mSATA solid-state drive storage converter to the chassis.
Figure 33. Installing the mSATA solid-state drive
9. Connect the signal cable and the power cable to the mSATA solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 93.
Replacing the mSATA solid-state drive
To replace the mSATA solid-state drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 32.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 32.
4. Locate the card reader drive bay. See "Locating internal drives" on page 13.
.
Chapter 5 Installing or replacing hardware
47