Step 4.
Reattach the computer cover.
Removing the front bezel
Note: For this procedure, it helps to lay the computer flat.
To remove the front bezel:
Step 1.
Remove the computer cover. Refer to "Removing the computer cover".
Step 2.
Remove the front top bezel. Refer to "Removing the front top bezel".
Step 3.
Remove the front bezel by releasing the three plastic tabs inside the chassis and sliding the bezel
out as shown.
Step 4.
To reattach the bezel, align the plastic tabs on the bottom of the bezel with the corresponding holes
in the chassis, and then snap it into position.
Step 5.
Reattach the front top bezel and computer cover.
Replacing the front USB/card reader/audio module
Note: For this procedure, it helps to lay the computer flat.
To replace the the front USB/card reader/audio module:
Step 1.
Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2.
Unplug all power cords from electrical outlets.
Step 3.
Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
Step 4.
Remove the computer cover. Refer to "Removing the computer cover".
Step 5.
Remove the top front bezel. Refer to "Removing the top front bezel".
26
IdeaCentre 710 Series