Completing The Parts Replacement - Lenovo ThinkStation E32 User Manual

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 93.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to reinstall the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 7 "Using the Setup Utility program" on page 103.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See "Locating components" on page 11 for the locations of various
components in your computer.
2. If you have removed the front bezel, reinstall it.
3. Ensure that the cables are routed correctly before reinstalling the computer cover. Keep cables clear of
the hinges and sides of the computer chassis to avoid interference with reinstalling the computer cover.
4. Press the release tab
Figure 105. Pivoting the drive bay assembly downward
1 as shown and pivot the drive bay assembly downward until it snaps into position.
.
Chapter 5 Installing or replacing hardware
93