AEG Protect D. 6000 (BP) Operating Instructions Manual page 29

ExPlaNatiONs:
1 Locking screws for the removable connection unit
2 Power input – separate connection of bypass (2.1) and rectifier unit (2.2)
is possible (dual input)
the feed can be run either from the rear-side or from the top of the cable glands
(illustration shows rear-side). if only one cable is to be laid, the portable bypass
feed (1.2) remains unused.
3 uPs output (load) over fixed connection
4 Locking screws for securing the bracket built into the manual bypass switch
connection unit
5 Manual bypass switch
6 consumer connection via iec60320 c19 sockets, automatic arrestor fitted
with an upstream fuse
7 consumer connection via iec60320 c13 sockets, automatic arrestor fitted
with an upstream fuse
taken from the consumer line by pressing the respective push button output of
each iec socket.
8 rs232 communication interface (sub-D9 jack)
9 usB communication interface
10 communication slot for optional extension cards:
relay card, card for remote on / off, snMP , ...
the usB and the rs232 communication interfaces cancel each other out, i.e.
either usB or rs232. the communication slot is dual-monitor enabled, i.e. can
be used parallel to the usB or rs232 interface.
29