Tuner Mode - Grundig Ovation CDS 6380 S User Manual

PRESET
!
f
PRESET
!
f
PRESET
! MHz
16 16

TUNER MODE

Selecting the tuner input source
1
Select the input source by pressing »
– The most recently selected station is activated (Last Station Memory).
– Display: e.g. »
Selecting a preset position
1
Select the frequency band (FM or MW) by pressing »
2
Select the preset position in steps by pressing »
– Display: for example »PRESET
Note:
Only stored station positions can be selected.
Stereo/mono reception
If the device receives an FM stereo station, » « appears in the display. If the
signal from the FM stereo station is weak, you can improve the sound quality by
switching to mono reception.
1
Press
– Display: »
2
To switch back to FM stereo, press
– Display: » «.
Note:
If the device is set to stereo reception and is receiving a mono signal, the
» « display flashes.
Automatic station search
By starting the automatic station search, you can delete all the existing preset
stations and replace them with new stations at the same time.
1
Start the automatic search in tuner mode by pressing and holding down
»PROG./RAND./TIME« on the remote control.
– After the search has finished, you will hear the station stored at position 01.
Note:
You can stop the automatic station search by pressing
TIME« on the remote control.
________________________________________________________________
« or »
»FM MODE« on the remote control to switch to mono reception.
« disappears from the display.
TUNER /BAND«.
«.
TUNER
5 a § « or »
« and the frequency or the station name.
»FM MODE« on the remote control.
»PROG./RAND./
/BAND«.
s s s 6 «.