Table of Contents
Advertisement
26
26
INFORMATION
Troubleshooting
Not every sound problem is necessarily caused by a defect in the your device. Defects can also be caused by
leads having been accidentally pulled out, damaged CDs and worn out batteries in the remote control. If the fol-
lowing measures do not do not rectify the problem, consult an authorised dealer.
Fault
No sound.
The system does not respond when the
buttons are pressed.
The remote control does not work.
Poor radio reception.
No playback through the headphones
or Aux input.
Tracks on a CD are skipped.
CD-Rs or CD-RWs are not played
back, or are played back incorrectly.
Cleaning the CD unit
If the device is unable to scan CDs perfectly, use a standard, commercially available cleaning CD to clean the
laser optics. Other cleaning methods may damage the laser optics.
To clean CDs use a lint-free cloth and wipe them in a straight line from the centre of the disc outwards. Do not use
cleaning fluid for vinyl records or other solvents or scouring agents.
Technical data
This device is noise-suppressed accor-
ding to the applicable EU directives.
This product fulfils the European direc-
tives 89/336/EEC, 73/23/EEC and
93/68/EEC.
This device conforms to the safety regu-
lation DIN EN 60065 (VDE 0860) and
therefore the international safety regu-
lation IEC 60065.
Amplifier unit
Output:
Sine wave power 2 x 3 W, 1 x 6 W
Music power 2 x 5 W, 1 x 10 W
_____________________________________________________________
Possible cause/remedy
The volume setting is too low – increase the volume.
The headphones are plugged in – disconnect the headphones.
The power cord is incorrectly connected – connect it
properly.
Mute is activated – deactivate Mute.
Static electrical discharge. Switch off the device, disconnect
the power cable and plug it in again after a few seconds
or press »RESET«.
The batteries are flat – replace the batteries.
The remote control is out of range of the stereo.
Weak antenna signal – check the antenna.
Weak FM-stereo signal – switch to Mono.
Interference from electrical devices such as televisions,
video recorders, computers, neon lamps, thermostats or
motors – keep the stereo away from such devices.
The headphones are plugged into the Aux input or the
external device is connected to the headphones output.
Reconnect the relevant plug correctly.
The CD is damaged or dirty – replace the CD or clean it.
The PROGRAM (track memory) or RANDOM functions
are active – deactivate the functions.
Faulty software or hardware settings during burning or the
CD itself.
Check the components of your CD burner/software or
change the CD being used.
Input sensitivity/
impedance
Aux 400 mV/22 k
Receiver unit
Reception range
FM 87.5 ...108.0 MHz
MW 522 ... 1620 kHz
CD unit
Frequency response
20 Hz ... 20 kHz
Noise-voltage
ratio:
(wtd.) > 70 dB
Technical and design modifications reserved.
System
Power supply:
Operating voltage 230 V~
Mains frequency 50/60 Hz
Max. power consumption 35 W
Power consumption in stand-by < 2 W
Dimensions and weight
Device dimensions
W x H x L 310 x 180 x 190 mm
Weight 3.9 kg
Hide quick links:
Advertisement
Table of Contents
