Settings; Setting The Clock - Grundig Ovation CDS 6380 S User Manual

SETTINGS

Setting the clock

PM
CT
____________________________________________________________________________
When the device is plugged in for the first time, the time and day displays will
flash indicating that they need to be set. The following settings may only be per-
formed in standby mode.
1
To set the 12-hour format, briefly press » PROG./RAND./TIME« on the
remote control.
– Display: briefly »
(»PM« for second half of the day).
2
To set the 24-hour format, press » PROG./RAND./TIME« on the remote
control again.
– Display: briefly »
3
To set the time, press and hold down » PROG./RAND./TIME« on the
remote control.
– Display: the hours flash.
4
Set the hours using »
RAND./TIME« on the remote control to confirm.
– Display: the minutes flash.
5
Set the minutes using »
RAND./TIME« on the remote control to confirm.
– Display: the day flashes.
6
Set the day using »
RAND./TIME« on the remote control to confirm.
– Display: e.g. » «.
7
To activate the RDS time synchronisation press » PROG./RAND./TIME«
again on the remote control.
Notes:
You must reset the time after a power failure or when the mains plug is pulled
out.
Some RDS stations transmit an RDS time signal. If RDS time synchronisation
is activated on the device (»
this new information. The »CT« display flashes. When the time synchronisati-
on has been completed successfully, the »CT« display remains fixed.
Time synchronisation can take several minutes, and even with good recepti-
on the accuracy depends on the time signal being transmitted. The automatic
setting is always activated when the device is switched from standby to tuner
mode and receives a suitable RDS station.
8
If you wish, you can deactivate RDS time synchronisation by pressing
» TUNING UP/DOWN« and confirm it by pressing »
TIME« on the remote control.
– Display: » «.
9
To switch the RDS time synchronisation on again, repeat steps
Note:
During the setting, if no button is pushed for more than 10 seconds, the device
ends the procedure automatically. You then have to start again.
«, then the current time, for example »PM
«, then the current time, for example »
TUNING UP/DOWN
TUNING UP/DOWN
« and press »
TUNING UP/DOWN
«), the time is automatically updated using
«
«.
« and press » PROG./
« and press » PROG./
PROG./
PROG./RAND./
1 to 7.
11