Fingerprint Reader Board - HP ENVY 15 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes bracket and cable)
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. mSATA SSD (see
c. Hard drive (see
d. Base enclosure (see
e. Base enclosure (see
f. Subwoofer (see
Remove the fingerprint reader board:
1. Release the ZIF connector (1) to which the fingerprint reader board ribbon cable is attached, and
then disconnect the fingerprint reader board ribbon cable from the system board.
2. Detach the fingerprint reader board ribbon cable (2) from the base enclosure. (The fingerprint
reader board ribbon cable is attached to the top cover with double-sided tape.)
3. Remove the Phillips PM2.0×2.9 screw (3) that secures the fingerprint reader board bracket and
board to the top cover.
4. Slide the fingerprint reader board bracket (4) to the left, and then lift it straight up to remove it.
Battery on page 41), and then remove the following components:
Service door on page
mSATA SSD on page
Hard drive on page 46)
Base enclosure on page
Base enclosure on page
Subwoofer on page 81)
42)
43)
53)
53)
Component replacement procedures
Spare part number
720543-001
85