Display Assembly - HP ENVY 15 Maintenance And Service Manual

Reverse this procedure to install the base enclosure.

Display assembly

NOTE: The TouchSmart touchscreen display assembly is spared only at the component level. The
non-touchscreen display assembly is spared at both the component and the subcomponent level. For
more display assembly spare part information, see the individual removal subsections.
Description
15.6 inch (39.80 cm), BrightView, FHD, LED, TouchSmart touchscreen display assembly
15.6 inch (39.80 cm), BrightView, HD, LED, TouchSmart touchscreen display assembly
15.6 inch (39.80 cm), BrightView, FHD, LED, non-touchscreen display assembly
15.6 inch (39.80 cm), BrightView, HD, LED, non-touchscreen display assembly
To remove the display assembly and access the display assembly subcomponents, follow these
steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. mSATA SSD (see
c. Hard drive (see
d. Base enclosure (see
Remove the display assembly:
1. Release the wireless antenna cables from the clips built into the left rear speaker (1), connector
board (2), and top cover (3).
2. Release the wireless antenna cables from the routing channel (4) between the subwoofer and
left front speaker.
3. Disconnect the display panel cable (5) and the webcam/microphone module cable (6) from the
system board.
Battery on page 41), and then remove the following components:
Service door on page
mSATA SSD on page
Hard drive on page 46)
Base enclosure on page
42)
43)
53)
Component replacement procedures
Spare part number
720550-001
720549-001
720552-001
720551-001
55