Hard Drive - HP ENVY 15 Maintenance And Service Manual

Reverse this procedure to install the WLAN module.

Hard drive

Description
1.5 TB, 5400 rpm, 9.5 mm (select models only)
1 TB, 5400 rpm, 9.5 mm
750 GB, 5400 rpm, 9.5 mm
640 GB, 5400 rpm, 9.5 mm (for use on computer models with an AMD processor)
500 GB 5400 rpm 9.5 mm
1 TB, 5400 rpm, +8 GB NAND hybrid, 9.5 mm
750 GB, 5400 rpm, +8 GB NAND hybrid, 9.5 mm
500 GB, 5400 rpm, + 8 GB NAND hybrid, 7 mm
256 GB SSD (for use on computer models with an Intel processor)
512 GB SSD (for use on computer models with an Intel processor)
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service door (see
Remove the hard drive:
1. Release the zero insertion force (ZIF) connector (1) to which the hard drive connector cable is
attached, and then disconnect the hard drive connector cable (2) from the system board.
2. Release the hard drive connector cable (3) from the opening in the base enclosure.
46 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Battery on page 41).
Service door on page
Spare part number
747375-001
676521-001
634250-001
669300-001
683802-001
731999-001
732001-001
732000-001
749761-001
749762-001
42).