Configuration Information - Factory Integrated Models - HP ProLiant SL4540 Specification

QuickSpecs

Configuration Information - Factory Integrated Models

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on
configurable product offerings and requirements.
NOTE: Factory Integrated Models must start with a CTO Server.
NOTE: FIO indicates that this option is only available as a factory installable option.
NOTE: All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
NOTE: Rack chosen is required to have 1200mm to provide space for cable management arm at the rear of the chassis and host PDU in
the rear of the rack
Step 1: Base Configuration (choose one of the following configurable models)
HP Chassis - 1x60 Model
HP Chassis - 2x25 Model
HP Chassis - 3x15 Model
HP Power Supplies
HP Rail Kits
Step 1A: Select Nodes
HP Server Nodes - 1x60
model
HP ProLiant SL454x 1x Node Chassis
NOTE: Standard 5 dual fan modules included along with chassis.
NOTE: Supports 60 LFF drives. One node total
HP ProLiant SL454x 2x Node Chassis
NOTE: Standard 5 dual fan modules included along with chassis.
NOTE: Supports 50 LFF drives with up to 25 per node. Two nodes total
HP ProLiant SL454x 3x Node Chassis
NOTE: Standard 5 dual fan modules included along with chassis.
NOTE: Supports 45 LFF drives with up to 15 per node. Three nodes total
NOTE: Prior to making a power supply selection it is highly recommended that the HP
Power Advisor is run to determine the right size power supply for your server
configuration. The HP Power Advisor is located at:
HP Common Slot Platinum Plus Power Supply Kits
NOTE: The following power supplies offer up to 94% efficiency.
HP 750W Common Slot Platinum Plus Hot Plug Power Supply Kit
HP 1200W Common Slot Platinum Plus Hot Plug Power Supply Kit
HP Common Slot Gold Power Supplies
NOTE: The following power supplies offer up to 92% efficiency.
HP 750W Common Slot Gold Hot Plug Power Supply Kit
NOTE: Kits contain optional power supply, an IEC power cable and PDU IEC cables.
NOTE: One Rail Kit is required for every chassis in a rack.
HP 4.3U Server Rail Kit
HP 0.66U Spacer Blank Kit
NOTE: A Spacer Blank kit may be ordered to make an even 5U (4.3U+0.66U) spacing in a
rack. This would enable racking of up to 8 chassis in a 42U rack. It is also possible to
rack up to 9 chassis in a 42U rack using an additional dense racking option kit. The
Spacer Blank kit is not used when the dense racking option HP 13U FIO Rack Adapter Kit
for 3x4.3U Chassis is used
HP ProLiant SL4540 Gen8 Tray 1x Node Server
NOTE: Select quantity of one
DA - 14406 North America — Version 16 — January 17, 2014
HP ProLiant SL4540 Generation 8 (Gen8) Server
www.hp.com/go/hppoweradvisor
663600-B21
663600-B22
663600-B23
656363-B21
656364-B21
512327-B21
681254-B21
681260-B21
664644-B21
Page 18