Clearing And Resetting Data - Strong SRT 5024 User Manual

Upgrading one SRT 5024 from another SRT 5024
Make sure both receivers are turned off before undertaking this procedure.
1. Connect a null modem cable between the RS-232 ports of both receivers.
2. Turn on the SRT 5024 that already has the latest software.
3. Turn on the SRT 5024 that needs to be upgraded.
4. Point the remote control at the receiver needing to upgraded and press UPGRADE .
The second SRT 5024 is upgraded. When the upgrading is finished, the second SRT 5024 will
restart.

Clearing and resetting data

You can also reset the SRT 5024, either by:
• clearing all the channels and stations or
• clearing all channels, stations, preferences and other user settings (thereby restoring the unit to
the default settings it had when it left the factory).
1. Press MENU on the remote control.
2. Press VOL or VOL
3. Press CH ▼or CH ▲ until Clear Data is highlighted.
4. Press OK.
The Clear Data window appears.
5. To clear all channels, stations, preferences and other user settings, select Reset to Defaults and
press OK.
A warning message advising you that if you continue, all settings will be returned to their factory
defaults. To continue, press OK; otherwise press MENU to cancel.
6. To clear all channels and stations, select Delete All Channels and press OK.
A warning message advising you that if you continue, all channels will be erased. To continue,
press OK; otherwise press MENU to cancel.
You will need to rescan in order to view channels or listen to radio stations.
until the Config option is highlighted.
36