Audio Settings - Sanyo VDC-DP9575P Manual For Remote Operation

AUDIO SETTINGS

1 Settings for voice reception
• AUDIO INPUT
Sets whether or not to input voice from the
camera.
Set to "ON" to listen to voice. You may choose to
use an externally connected microphone
(EXTERNAL) or the built-in microphone on the
camera (INTERNAL).
• MIC SENSITIVITY
Sensitivity for the microphone connected to the
camera can be selected out of eight levels.
• FILTER (500Hz)
Allows you to set a filter for voice.
Limits mechanical noise from cameras with
panning-tilt functions.
2 Settings for voice transmission
• AUDIO OUTPUT
Sets whether or not to output voice to the
speakers connected to the camera. Set to "ON"
when outputting voice from the PC microphone
to the speakers on the camera side.
• OUTPUT LEVEL
Output volume from the speakers connected to
the camera can be selected out of four levels.
• MUTE
When set to "ON", voice output from the PC
speakers is muted during "PAN/TILT" or "ZOOM"
operation.
English
1
2
3
4
Note:
When [RESOLUTION] is configured to 640 x 480 on the [IMAGE TRANSFER
SETTINGS] screen, the [AUDIO INPUT]/[AUDIO OUTPUT] setting cannot be
configured to "ON".
3 AUDIO PORT NUMBER
Set the number of the port for voice
communications.
Note:
• The following port numbers cannot be set: 1024
or less, 3000 - 5000, 10000, 10001, and 38214.
• Set the audio port number, making sure that it
doesn't overlap with the value of the [PORT
NUMBER] on the [NETWORK SETTINGS]
screen.
4 [SET] button
After completing the settings, click this button to
confirm the settings.
19
("admin" only)