Image Transfer Settings; For Http Connection - Sanyo VDC-DP9575P Manual For Remote Operation

IMAGE TRANSFER SETTINGS

■ For HTTP connection

When you want to record or play the video in HTTP mode, use the separately ordered "VA-SW3050"
recorder/player software. The recording configuration will be made on the VA-SW3050 screen.
When you use "VA-SW3050", the HTTP mode is automatically selected in the [IMAGE
TRANSMISSION] setting and the FTP mode cannot be used.
1 IMAGE TRANSMISSION
Set the image transfer mode to "HTTP".
2 LIVE/NORMAL RECORD
Sets the image conditions as well as activates/
deactivates the voice recording for live video and
normal recording.
• RESOLUTION
• QUALITY
• AUDIO
Note:
• When either [AUDIO INPUT] and/or [AUDIO
OUTPUT] are configured to "ON" on the [AUDIO
SETTINS] screen, [RESOLUTION] cannot be
configured to 640 x 480.
• When the [AUDIO INPUT] setting on the [AUDIO
SETTINGS] screen is configured to "OFF",
[AUDIO] cannot be configured here.
3 ALARM
1
Sets the image conditions as well as activates/
deactivates the voice recording for alarm
recording.
• RESOLUTION (see the "Note" above.)
• QUALITY
• AUDIO (see the "Note" above.)
2
Select the [BUFFER SIZE] option for specifying
the buffering capacity on the camera used for
recording the alarm image. According to the
option you selected, perform the following
settings:
1
2
1
3
2
4
When the [BUFFER SIZE] setting is set from
"0.5MB to 8MB"
One alarm image set containing both the pre- and
post-alarm images is stored in the camera, and then
the alarm image set is transferred one by one to the
"VA-SW3050" software.
Configures the recording capacity ratio
PRE/
between the pre- and post-alarm image
POST
recordings.
Configures the recording rate for the
RATE
alarm image.
Note:
If [PRE/POST] is set at other than "0%/100%", the
[LIVE/NORMAL RECORD (2)] setting cannot be
changed.
When the [BUFFER SIZE] setting is set to "OFF"
When the alarm is detected, only the post-alarm
images will be transferred to the "VA-SW3050"
software. The transfer speed depends on the
network environment.
Specifies the duration of each alarm
image to transfer (During this
DURATION duration, no other alarms can be
processed for transferring the alarm
image).
4 [SET] button
After completing the settings, click this button to
confirm the settings.
16
("admin" only)
English