Part Identification Chart; Assembly - Weider 350 Bench User Manual

ASSEMBLY

Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. By setting aside
plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the fol-
lowing information and instructions:
• To hire an authorized service technician to
assemble the weight bench, call 1-800-445-2480.
• Assembly requires two persons.
• Because of its size, the weight bench should be
assembled in the location where it will be used.
Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
1.
Before beginning assembly, make sure
you understand the information in the
box above.
Orient the Bench Rear Stabilizer (2) so that the
warning decal is in the position shown. Attach
the Bench Rear Stabilizer to the Bench Frame
(1) with two M10 x 62mm Carriage Bolts (97)
and two M10 Nylon Locknuts (80). Do not
tighten the Nylon Locknuts yet.
2. Attach the Front Leg (3) to the Bench Front
Stabilizer (5) with two M10 x 68mm Bolts (85),
four M10 Washers (83), and two M10 Nylon
Locknuts (80). Do not tighten the Nylon
Locknuts yet.
Attach the Front Leg (3) to the Bench Frame (1)
with two M10 x 68mm Bolts (85), four M10
Washers (83), and two M10 Nylon Locknuts
(80). Do not tighten the Nylon Locknuts yet.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• Assembly requires the included hex key(s)
and the following tools (not included):
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
1
2
3
83
80
83
6
80
Warning
2
Decal
97
1
80
83
85
83
83
85
83
5