Assembly - ProForm 545 Ekg Elliptical User Manual

ASSEMBLY

Assembly requires two people. Place all parts of the elliptical trainer in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included hex key, assembly requires a phillips screwdriver
spanners
Use the chart below to identify the small parts used in assembly. The number in parenthesis below each part
refers to the key number of the part, from the PART LIST on page 14. The number after the dash indicates the
quantity needed for assembly. Note: Some parts may have been pre-attached for shipping. If a part is not
in the parts bag, check to see if it has been pre-attached.
M8 Nylon
Locknut (38)–6
M8.5 Large
Washer (35)–2
M8 x 45mm Button Bolt (50)–4
M10 x 76 mm Button Bolt (27)–2
, a rubber mallet
M10 Nylon
Locknut (33)–6
M4 x 16mm M4 x 19mm Flange
Screw (52)–4
Screw (36)–6
, and a pair of pliers
M10 Split Wave Washer
Washer (59)–4
M4 x 22mm
Screw (42)–2
Pedal Arm Bolt Set (40)–2
M10 x 75mm Carriage Bolt (34)–4
4
, two adjustable
.
M8.5
(75)–2
Washer (55)–2
M8 x 25mm Patch
Screw (56)–2