ProForm 545 Ekg Elliptical User Manual page 7

7. Apply a generous amount of the included grease to
the Pivot Axle (73) and to the two M8.5 Washers (55).
Next, insert the Pivot Axle into the Upright (2) and cen-
tre it. Reapply grease to both ends of the Pivot Axle.
Slide a Handlebar Spacer (47) onto the short tube on
each Handlebar (6, 8), and rotate the Handlebar
Spacers so the small arrows are pointing toward the
floor. Then, slide the Handlebars onto the Pivot Axle
(73). Make sure that the Handlebars are on the cor-
rect sides.
Tighten an M8 x 25mm Patch Screw (56) with an M8.5
Washer (55) and a Wave Washer (75) into each end of
the Pivot Axle (73). Next, orient the two Handlebar
Caps (46) as shown, and press the small tabs on the
Handlebar Caps into the two Handlebar Spacers (47).
8. Apply a generous amount of grease to the axle on
the left Disc Crossbar (16). Slide the Left Pedal Arm
(11) onto the axle and attach it with an M8.5 Large
Washer (35) and an M8 Nylon Locknut (38).
Insert the left Handlebar Arm (5) into the bracket on
the end of the Left Pedal Arm (11), and attach it with
a Pedal Arm Bolt Set (40).
Repeat this step to attach the right Pedal Arm (not
shown).
See step 6. Tighten the M8 x 45mm Button Bolts (50)
in the Handlebar Arms (5).
Tighten the two M10 x 76mm Button Bolts (27).
9. Find the Left Pedal (13), which has a ridge on the
right side. Attach the Left Pedal to the Left Pedal Arm
(11) with three M4 x 19mm Flange Screws (36) as
shown.
Attach the Right Pedal to the Right Pedal Arm (not
shown) in the same way.
10. Make sure that all parts of the elliptical trainer are properly tightened. Place a mat under the elliptical
trainer to protect the floor or carpet from damage.
7
6
55
56
75
46
8
5
40
40
11
9
11
7
Grease
73
47
Arrow
2
27
16
Grease
35
38
13
36
8
46