6
CONTROLS
6.6
Light switch
6.7
Electric starter button (Freeride 250 R EU)
6.8
Electric starter button (Freeride 250 R AUS)
6.9
Turn signal switch
6.10
Emergency OFF switch (Freeride 250 R AUS)
The light switch
Possible states
B01658-12
Electric starter button
Possible states
•
Electric starter button
•
Electric starter button
B01659-10
Electric starter button
Possible states
•
Electric starter button
•
Electric starter button
B01663-11
Turn signal switch
Possible states
602801-10
The emergency OFF switch
Possible states
B01663-10
is fitted on the left side of the handlebar.
1
Light off – Light switch is turned to the right. In this position, the light
is switched off.
Low beam on – Light switch is in the central position. In this position,
the low beam and tail light are switched on.
High beam on – Light switch is turned to the left. In this position, the
high beam and the tail light are switched on.
is fitted on the right side of the handlebar.
1
in basic position
pressed – In this position, the electric starter is actuated.
is fitted on the right side of the handlebar.
1
in basic position
pressed – In this position, the electric starter is actuated.
is fitted on the left side of the handlebar.
1
Turn signal light off – Turn signal switch is in the central position.
Turn signal light, left, on – Turn signal switch is turned to the left.
Turn signal light, right, on – Turn signal switch is turned to the right.
is fitted on the right side of the handlebar.
1
Ignition off – In this position, the ignition circuit is interrupted, a run-
ning engine stops, and a non-running engine will not start.
Ignition on – In this position, the ignition circuit is closed and the
engine can be started.
13