Changing The Turn Signal Bulb; Checking The Headlight Setting; Adjusting The Headlight Range - KTM 2014 Freeride 250 R Owner's Manual

15 ELECTRICAL SYSTEM
15.9

Changing the turn signal bulb

Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
15.10

Checking the headlight setting

A 0 0 A
15.11

Adjusting the headlight range

Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
–
Lightly squeeze orange cap
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
800137-10
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W/socket BA15s) (
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
Finishing work
–
Check that the turn signal system is functioning properly.
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
Guideline
Distance
B 0 0 B
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Adjust the beam distance of the headlight by turning screw
Guideline
For a motorcycle with rider, the light/dark boundary must be exactly on the lower
mark (the mark is created in: Checking the headlight setting).
B01043-10
.
1
in the area of the holding lugs and take it off.
2
under the first mark.
B
B
A
p. 77)
p. 96)
5 cm (2 in)
away from the wall.
A
5 m (16 ft)
p. 77)
.
1
77