GE SG SERIES 10 Operating Manual page 40

g
Code Message
BYPASS
4535
LOCKED
BYPASS
4536
FREE
TOTAL
4561
OFF
DETOUR
4562
ON
DETOUR
4564
OFF
COMMAND
4567
LOAD ON UTILITY
COMMAND
4568
LOAD ON INVERTER
NO MORE
4572
OVERLOAD
INVERTER AND
4580 UTILITY
SYNCHRONIZED
COMMAND
4582
NOT TO
SYNCHRONIZE
COMMAND TO
4583
SYNCHRONIZE
Q1
4602
OPEN
Q1
4603
CLOSED
BATTERY TEST
4699
IMPOSSIBLE
REMOTE CONTROL
4763
ON
REMOTE CONTROL
4764
OFF
OPM_SGS_USM_10K_40K_0US_V010.doc
Bypass is not available.
Contactor K6 and K8 are open, SSM deactivated.
Bypass is enabled.
Contactor K6 is closed.
Push-button "total off" on the UPS Control Panel has been
pressed, with the output circuit switch Q1 closed.
The auxiliary contact indicates that Manual Bypass Q2 was
closed.
The auxiliary contact indicates that Manual Bypass Q2 was
opened.
The control unit received a command to transfer the Load on
Utility.
The control unit received a command to transfer the Load on
Inverter.
End of the overload condition detected with alarm 4570.
The voltages of Inverter and Utility Bypass are synchronized.
Command not to synchronize with Utility.
Command to synchronize with Utility.
The auxiliary contact indicates that the output switch Q1 was
opened.
The auxiliary contact indicates that the output switch Q1 was
closed.
Automatic Battery Test is not possible due to:
No Utility Rectifier or Bypass.
Battery not fully charged.
Load is below 10% or above 80%.
Test is postponed for 1 week.
Inverter can be started or shutdown by remote control.
Commands source can be chosen depending on the value of
parameter (Service only):
0 = Only local panel.
1 = Only serial port on CI.
2 = Both.
Inverter cannot be started or shutdown by remote control.
Commands source can be chosen depending on the value of
parameter (Service only):
0 = Only local panel.
1 = Only serial port on CI.
2 = Both.
40/88
Meaning
Operating Manual SG Series 10, 20, 30 & 40 kVA
GE