Ceiling-Suspended Installation - Panasonic AW-HE2P Operating Instructions Manual

Ceiling-suspended Installation

When installing the camera by suspending it from the ceiling, be sure to attach the
drop-prevention wire.
1
Mount the stand to the ceiling using the M4
screws (supplied).
≥ Tightening torque: 1.176 N·m (12 k
≥ Screw the stand's three holes.
≥ Do not use any screws other than those supplied with the unit (do
not use wood screws, nails, etc.).
≥ Make sure the stand is firmly mounted to the ceiling, with no tilting
or wobbling.
≥ Screw the drop-prevention wire separately to the stand.
2
Mount the drop-prevention wire to the ceiling
by using the M4 screw (supplied) and the flat
washer (for M4 screw, supplied).
≥ Tightening torque: 1.176 N·m (12 k
≥ Pull the drop-prevention wire, and check that it has been
attached securely.
≥ The drop-prevention wire is designed to be used for installation where the unit is
suspended from an overhead surface so do not subject it to the weight of units other than
the unit.
g
f·cm)
g
f·cm)
21
VQT4N15