Mount To A Tripod - Panasonic AW-HE2P Operating Instructions Manual

Mount to a Tripod

The tripod mounting hole of the unit supports 1/4-20UNC.
≥ Loosen the horizontal fixing screw (l 10)
1
Remove the stand fixing
screw A and spring washer
B, and detach the stand
protruding portion C.
j The stand protruding portion can be
used as a tripod mounting hole.
2
Insert the stand protruding portion in the
stand mounting hole, and tighten the
horizontal fixing screw.
≥ Tightening torque: 1.176 N·m (12 k
3
Mount a tripod to the tripod mounting hole D.
≥ Place the tripod on a completely flat and level surface.
≥ Tighten the screws by hand to mount the tripod securely.
≥ Do not install the unit where people will be passing back
and forth.
≥ When using the unit mounted on a tripod, do not put the
tripod high above the floor level.
≥ Mount the unit securely so there is no looseness.
Looseness may cause the unit to fall off and/or result in
injuries.
≥ When the unit is going to be used for a prolonged period
of time, take steps to ensure that the unit will not topple or
fall over and that it will not fall off or fall down. After using the unit, restore the installation
location to its original state without delay.
∫ To return the stand to the condition it was in when you purchased it,
Use the stand fixing screw and spring washer to screw the stand protrusion to the stand.
≥ Align the stand protruding portion and the stand correctly so that the stand protruding
portion does not turn.
≥ Tightening torque: 2.94 N·m (30 k
g
f·cm)
g
f·cm)
23
VQT4N15