Panasonic AW-HE2P Operating Instructions Manual page 9

∫
When the rear cover is detached
11
12
13
11 RELEASE lever (l 12)
12 USB terminal [
Power can be supplied from any device that
complies with USB battery charging
standards, including Micro USB AC/DC
converters for ordinary cell phones, personal
computers, or televisions. When doing so,
use the USB cable.
≥ Always use a genuine Panasonic USB
cable (K2KYYYY00221: optional).
13 HDMI terminal (l 20)
14 Drop-prevention wire mounting
portion (l 20)
15 LAN connector (l 20)
Use a category 5 or above LAN cable with a
maximum length of 100 m (328 ft.).
16 LAN lamp [LINK/ACT]
Lights up when data is transmitted/received
via LAN.
17 microSD card slot
This portion is used when updating the
firmware of the unit. (Not ordinarily used)
≥ Keep the microSD card out of reach of
children to prevent swallowing.
∫
When the middle ring portion is detached
20
14
15
16
](l 20)
18 INIT button
If you press the button while the unit is
turned on, the user management settings
and the network settings are initialized.
Initialize using the following procedure.
1) Close the camera menu and the web
settings screen.
2) Press the INIT button.
3) Switch on the power again using the
power button.
19 Power button [
If you press the button when the unit is in
standby mode or turned off, the unit is turned
on. If you press and hold the button when
the unit is in standby mode or turned on, the
unit is turned off.
20 DC input terminal [DC IN] (l 20)
≥ Do not use any other AC adaptors except
the supplied one.
17
18
19
]
9
VQT4N15