Panasonic AW-HE2P Operating Instructions Manual page 17

≥ Secure the AC adaptor firmly so that there will be no chance that it will fall off or fall down.
Secure it using a strength which can withstand the mass (approx. 0.1 k
AC adaptor.
Install the accessory AC adaptor near the main power outlet, and position it in such a
way that its power plug can be plugged into and unplugged from the outlet easily.
When connecting the AC adaptor to a power outlet on the ceiling or on any other surface
where dust may collect, wipe off the dust on the power plug at periodic intervals as an
anti-tracking measure.
Connecting the AC cable
Be absolutely sure to connect the AC cable of the AC adaptor through a circuit breaker using
one of the following methods.
1) Connect the power cable through a power control unit.
2) Connect the power cable to a circuit breaker in a power distribution panel with a contact
distance of 3.0 mm or more. Use a circuit breaker which is capable of shutting off all the
poles of the main power supply with the exception of the protective ground conductor.
3) Install the AC adaptor near the power outlet, and connect it through the power plug.
If there is a possibility of noise interference
Either wire the cables so that the power cable (ceiling light cord) of AC 100 V* (AC 220 V**)
or more, and the signal cable are placed at least 1 m (3.3 ft.) apart.
Alternatively run each cable through its own metal conduit.
(The metal conduits must be grounded.)
Radio signal interference
If the unit is positioned near a TV or radio transmitting antenna or a strong electrical field or
magnetic field (such as that generated by a motor, transformer or power lines), its images
may be distorted and/or the images may be affected by noise.
When connecting the cables, ensure that the connector areas will not be subject to
any load.
Doing so may cause malfunctioning.
Allowing the generated heat to escape
This unit allows the heat generated inside to escape from its surfaces.
Do not install the unit in a location where it will be surrounded by walls or other surfaces and
where heat will be trapped.
g
(0.22 lb.)) of the
*For AW-HE2P
**For AW-HE2E
17
VQT4N15