Panasonic AW-HE2P Operating Instructions Manual page 16

Do not install or use the unit in the following kinds of locations.
≥ On walls (where the unit would be installed sideways)
≥ In locations (including places such as under the eaves of a building) where the unit would
be directly exposed to rain or water
≥ In locations such as kitchens where there are high concentrations of steam and grease
≥ In outdoor locations or hot places where the temperature will exceed 40 oC (104 °F)
≥ In cold locations where the temperature will drop below 0 oC (32 °F)
≥ In locations where the humidity will exceed 80%RH
≥ In locations where chemicals are used such as near swimming pools
≥ At sea, in coastal areas or in locations where corrosive gases are emitted
≥ In locations where radiation, X-rays, or strong radio waves or magnetic fields are
generated
≥ In locations where the unit would be subject to a great deal of vibration such as on board a
vehicle or ship (this unit is not designed to be used in vehicles)
≥ In locations where the temperature is subject to sudden changes such as near the air
outlet of an air conditioner or near a door which allows the outside air to come in
What to avoid to ensure that the unit will perform stably over a prolonged period.
≥ Using the unit for a prolonged period in a location with high temperature and humidity
levels will cause its parts to deteriorate and shorten its service life.
≥ Ensure that a cooling unit or heating unit will not blow any air directly toward the installation
location.
Be absolutely sure to use the supplied stand and screws to install the camera.
≥ Do not mount the unit by employing any methods other than those specified.
≥ Do not remodel the stand or screws provided with the unit.
Before installation, always disconnect the power plug.
Tightening up the mounting screws
≥ Tighten up the screws and bolts securely to the degree that is appropriate for each of the
materials used in the mounting location and structures.
≥ After tightening up the screws and bolts, check that there is no unsteadiness and that the
parts have been tightened securely.
≥ Use the specified tools and tighten the screws firmly.
≥ Tighten up the screws using the specified torque driver. Do not use electrical drivers or
impact drivers.
When the unit is no longer going to be used, do not leave it lying around, but be
absolutely sure to dispose of it properly.
Do not attach a filter, hood, extender or other parts to the unit.
Use the dedicated AC adaptor and AC cable provided with the unit.
Connect the AC adaptor and AC cable to the power inlet securely.
Installing the AC adaptor
≥ Do not place the AC adaptor directly onto a ceiling panel or other such surface.
Extreme danger is posed when water has collected on the surface as a result of leaking
rain, for instance.
Secure the AC adaptor firmly to the bottom or other surface of a reinforcing member made
of channel steel where dust will not accumulate.
16
VQT4N15