Panasonic AW-HE2P Operating Instructions Manual page 36

Do not touch the optical system.
Under no circumstances must they be touched.
In the unlikely event that they have become dusty, remove the dust by using a camera blower
or by wiping them gently with a lens cleaning paper.
Do not point the camera directly at the sun or a laser beam.
Taking images of the sun, laser beams, or other brightly lit subjects for prolonged periods of
time may damage the MOS sensor.
Do not use the unit for long periods of time.
Continuous use could cause the unit to overheat and cause a malfunction.
Personal computer used
If the same image is displayed for a prolonged period on a PC monitor, the monitor may be
damaged. Use of a screen saver is recommended.
Concerning the IP address setting
Do not run the Easy IP Setup Software on a multiple number of personal computers for a
single camera and set the IP address at the same time.
Otherwise, you will be unable to complete the proper procedure and set the IP address correctly.
Keep the unit away from water.
Avoid all direct contact with water. Otherwise, problems may occur.
Maintenance
Turn off the unit's power before proceeding with maintenance. Otherwise, you may injure yourself.
Wipe the surfaces using a soft dry cloth. Avoid all contact with benzene, paint thinners and
other volatile substances, and avoid using these substances. Otherwise, the casing may
become discolored.
Use the unit in an environment with minimal moisture and dust.
Avoid using the unit in an environment with high concentration of moisture or dust since
these conditions will damage the internal parts.
Disposal of the unit
When the unit has reached the end of its service life and is to be disposed of, ask a qualified
contractor to dispose of the unit properly in order to protect the environment.
Keep this unit as far away as possible from electromagnetic equipment (such as
microwave ovens, TVs, video games etc.).
≥ If you use this unit on top of or near a TV, the pictures and/or sound on this unit may be
disrupted by electromagnetic wave radiation.
≥ Do not use this unit near cell phones because doing so may result in noise adversely
affecting the pictures and/or sound.
≥ Electromagnetic wave radiation generated by microprocessors may adversely affect this
unit, disturbing the pictures and/or sound.
≥ If this unit is adversely affected by electromagnetic equipment and stops functioning
properly, turn this unit off and disconnect AC adaptor. Then reconnect AC adaptor and turn
this unit on.
Do not use this unit near radio transmitters or high-voltage lines.
≥ If you record near radio transmitters or high-voltage lines, the recorded pictures and/or
sound may be adversely affected.
36
VQT4N15