Troubleshooting - Strong SRT 5405 User Manual

Troubleshooting

There may be a number of causes of abnormal operation. Occasionally receivers can hang (just as
a PC will do from time to time). In this case, you should disconnect the
power, wait 30 seconds and then reconnect it to mains power. If the unit is still not operating
correctly, refer to the following table for the indicated problem and likely solution.
Symptoms
Indicators on front
panel do not light up
No picture and
sound
Picture and/or audio
glitch
No sound
Remote control is not
working
Music files on a USB
memory stick don't
appear
Possible causes
AC power cord is not
connected
The cables connecting the
TV and the receiver are
not properly connected
The TV mode is not correct
Incorrect video definition
Insufficient signal strength
Electrical interference
The receiver or TV is in
mute mode
Initial volume level has not
been set on your TV
Batteries not inserted
Batteries are flat
Remote control is outside
the range of operation
Files are of wrong format.
Files are not at the root or
top level.
Check that the power cord is plugged into
the wall socket.
Make sure the power switch is on.
Make sure that the correct cable is
connected between the TV and the receiver,
and that the antenna is connected.
Check that the correct video or AV input has
been selected on your TV.
If you have a Composite or S-Video
connection to your TV, video definition must
be set to 576i. Press EXIT and then FORMAT on
the remote control until you see a picture.
Check that the antenna cable is securely
plugged in and that the signal is adequate.
Check that all antenna cabling is quad-
shielded.
Press the MUTE button on the receiver and on
the TV.
Select the desired TV volume level using the
TV remote control.
Insert batteries
Change the batteries in the remote control.
Aim the remote control directly at the
receiver.
Check that the format is, MP3.
Move the files out of folders or directories.
37
from mains
Solution