2. MAJOR UNIT REPLACEMENT
2.5
Replacing the Stepping Motor
1)
Remove the Right Cover, Left Cover and Front Cover. (Refer to Section 2.1 Replacing the CPU PC
Board.)
2)
Remove the two Gears.
3)
Remove the two screws.
NOTE: When replacing the gear, apply a small amount of Floil (8mm
by drawing a line around the part as shown below.
Stepping Motor
Gear
3
) to each Gear Stud with a toothpick, etc.
Gear Stud (2 places)
Gear Stud
2-12
(Revision Date: Mar. 17, 2009)
2.7 Replacing the Stepping Motor
SMW-2x6 Screw
FLOIL
EO18-33024