GE JKP17 Use And Care Manual page 31

fter Self-Cleaning
You may notice some white ash in the oven. Just wipe it up with a damp
cloth after the oven cools.
If white spots remain, remove them with a soap-filled steel wool pad. Be
sure to rinse thoroughly with a vinegar and water mixture. These deposits
are usually a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after 1 clean cycle, repeat the cycle.
NOTE: No functions can be programmed before the door automatically
unlocks.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the CLEAN pad.
4. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
5. Press the STOP TIME pad.
6. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of clay.
1. Follow steps to prepare the oven for cleaning.
2. Press the CLEAN pad.
CLEAN
A pad to enter the Clean Time.
4. Press the STOP TIME pad.
"SET STOP TIME" and the earliest
STOP
Stop Time you can set will appear in
TIME
the display.
The earliest Stop Time will be the Clean Time
selected plus the time of day. For example: If
the Clean Time is 3 hours and the time of day
is 6:00, the Stop Time that appears in the display
will be 9:00.
Press the INCREASE pad to change the Stop
5.
Time to a later time of day if desired. For example:
If you set the Stop Time at 11 :00, the oven will start
the clean cycle at 8:00 and end at 11 :00. The door
latches automatically.
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the clean
cycle is set. The words "ON" and "LOCK" will
appear in the display when the door automatically
locks. [t will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
6. When the. LOCK light is off, open the door.
NOTE: During a delayed self-clean operation you
can find out when the oven is set to turn on by
pressing and holding the CLEAN pad for 3 seconds.
(continued next
31