GE JKP17 Use And Care Manual page 30

OPERATING THE SELF-CLEANING OVEN
How to Set Oven for Cleaning
Quick Reminder:
1. Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the CLEAN pad.
4. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
cycle, the word "OFF" will appear in the display.
Allow additional time for cooling before you try
to set the cycle.
1. Follow the directions to prepare the oven for
cleaning.
2. Press the CLEAN pad.
CLEAN
3. Press the lNCREASE or
DECREASE pad until the
desired Clean Time is displayed.
Clean Time is normally 3 hours. You
can change the Clean Time to anywhere
between 2 and 4 hours, depending on
how dirty your oven is.
To Stop a Clean Cycle
1. Press the CLEAJUOFF pad.
CLEAR
OFF
30
(continued)
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the clean
cycle is set. The words "ON" and "LOCK" will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature ~nd the LOCK light goes off.
4. When the LOCK light is off, open the door.
NOTE: You can find out when the
clean cycle will be finished by
STOP
pressing the STOP TIN4E button.
TIME
The word "door" will be displayed, the word "LOCK"
will flash and oven control will signal if you set the
clean cycle and forget to close the oven door.
2. Wait until the oven has cooled below locking
temperature. You will not be able to open the
door right away unless the oven temperature is
at a safe level.
.