Healthrider H85t Treadmill Manual page 9

5. Identify the Right Upright (79) and the Right
Upright Spacer (83). Insert the Wire Harness
(86) through the Right Upright Spacer as shown.
Set the Right Upright Spacer on the Base (60).
With the help of a second person, hold the Right
Upright (79) near the Base (60). See the inset
drawing. Tie the wire tie in the Right Upright
securely around the end of the Wire Harness
(86). Then, pull the other end of the wire tie until
the Wire Harness is routed through the Right
Upright.
6. Hold a Screw Spacer (84) inside the lower end
of the Right Upright (79). Insert a 3/8" x 4" Screw
(5) with a 3/8" Star Washer (12) into the Right
Upright and the Screw Spacer. Repeat this step
with a second Screw Spacer (84), 3/8" x 4"
Screw (5), and 3/8" Star Washer (12).
Hold the Right Upright (79) against the Right
Upright Spacer (83). Be careful not to pinch
the Wire Harness (86). Tighten the 3/8" x 4"
Screws (5) until the heads of the Screws touch
the Right Upright; do not fully tighten the
Screws yet.
5
86
Wire Tie
79
Wire
86
Tie
6
79
9
79
83
60
5
12
86
84
83