Healthrider H85t Treadmill Manual page 11

10. Insert the bracket on the Left Handrail (106) into
the top of the Left Upright (77).
Attach the Left Handrail (106) to the Left Upright
(77) with three 5/16" x 3/4" Bolts (4) and three
5/16" Star Washers (9); do not fully tighten the
Bolts yet.
11. Have a second person hold the console assem-
bly near the Right Upright (79). Connect the
Wire Harness (86) to the console wire. See the
inset drawing. The connectors should slide
together easily and snap into place. If they
do not, turn one connector and try again. IF
THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN YOU TURN ON THE POWER.
Remove the wire tie from the Wire Harness.
Insert the connectors and the excess wire into
the Right Handrail (105).
Set the console assembly on the Right Handrail
(105) and Left Handrail (not shown). Be careful
not to pinch the wires.
12. Be careful not to pinch the wires in the Right
Handrail (105).
Attach the console assembly to the Right
Handrail (105) with two #8 x 3/4" Screws (1) and
a 1/4" x 1 1/4" Screw (6) with a 1/4" Star Washer
(10). Repeat this step on the left side of the
console assembly. Start all six Screws before
tightening them.
See step 5 and steps 7––9. Tighten all of the
screws and bolts used in these assembly
steps.
10
106
11
Console
Assembly
86
105
Wire Tie
79
12
Console Assembly
105
1
10
6
11
4
9
4
77
Console
Wire
Console
Wire
86