Unlock Scanner; Connect Scanner; To The Power Adapter - Microtek ScanMaker i800 Plus Start Here Manual

Step 3:
A. Remove the yellow "Step 3" sticker from
your scanner.
B. With the scanner power off, tilt the back left
corner of the scanner to see the locking
switch at the bottom.
C. Push the locking switch to the position (as
indicated by the graphic on the right), with
the icon on the lock showing as "unlocked".
D. Raise the scanner lid (TMA), and look for the
locking switch at the base of the TMA.
E. Push the locking switch to the position (as
indicated by the graphic on the right), with
the icon on the lock showing as "unlocked".
NOTE: To lock the scanner (for shipping and other reasons), refer to
the ScanMaker i800 Plus Supplement.
Step 4:
To the digitizer lid
Make sure the scanner lid (TMA) is properly installed, with
its connector securely connected to the scanner's 15-pin
accessory port.

To the power adapter

A. Remove the yellow "Step 4"
sticker from your scanner.
B. Connect the power adapter to
the back of the scanner.
C. Plug one end of the power cord
into the socket of the power
adapter, and plug the other end
into a wall outlet or other power
source.

Unlock Scanner

Connect Scanner

2
Locked
Unlocked
Locked Unlocked